Start with unboxing the machine order as shown in the video below.
When you first get your machine you will need to remove shipping bolts, install into the enclosure, hook up an air supply, and install the tool.
Removing Shipping Bolts
There are four shipping bolts installed in the Pocket NC in order to lock the axes in position and prevent damage to the machine during shipment. Please see the video below to identify and remove the proper bolts. Do not remove any other bolts as these may cause the machine to become uncalibrated.
These bolts must be removed before the machine may be used. The bolts are M6x8x25 shoulder bolts. The 4 mm hex key is needed to remove them is included in the kit shipped with the machine. The bolts are installed only hand-tight.
Do not discard the bolts. They should be retained with the rest of the machine packaging in case the user needs to ship the machine in the future.
The locations of the 4 shipping bolts are shown in the images below. Two of the shipping bolts are located behind the Y-axis. When the user is looking at the back of the machine they are located in the lower-right quadrant of the machine.