You should only need to do the following steps once, but if you ever need to take the fixture off to clean the machine then follow these steps in reverse to remove the fixture and in order to put it back on.
- Next, install the fixture onto the machine, you will need the items shown below. From left to right in the foreground of the machine is the dental hardware packet with dowel pins and M4x6 socket head screws (note there is extra hardware in this packet so keep it accessible in case you lose any parts), an M3 hex screwdriver, and the dental fixture.
- Install the four dowel pins into the B table as shown.
- Install the fixture in the orientation shown. The narrower ball screws should point towards the spindle, while the wider ball screws open to the side of the machine. It is important to make sure that the fixture is flat and fully seated on the dowel pins.
- Install the M4x6 socket head screws. Tighten with the M3 hex screwdriver.